Why all the comparisions

JoseB · Joined: 04 Jul 2023 Posts: 3

I create a lot of comparisons. For instance Canon RP Source folder to Canon RP Target Folder on Hard Drive G. I also have the same source going to Hard Drive H, I, K, M, N, NAS 1 and NAS 2.

But when I click on just one of them all of them tend to show up. I just want the comparison I clicked to show up not all 21 that I created. Meaning not all 21 Source and Target comparison. Why does this program do that? Or am I suppose to delete these comparisons after using them?

TGRMN Software · Site Admin Joined: 10 Jan 2005 Posts: 8769

Hi, when a source / target pair is added to a profile, all the pairs are always compared when clicking "compare". To only compare a specific source/target combination, create a separate profile each pair , save if to .fsf, then you can open that specific fsf when wanting to compare that source/target pair.
In Tools -> Shortcut Creation you can also create shortcuts to profiles and save them all at the same location, so then you can start a specific shortcut.
However the possibility to only compare one pair in a profile with multiple sources / targets would be quite useful, I have noted this down for a possible improvement in the next release. Thank you for the feedback!
_________________
--
TGRMN Software Support
http://www.tgrmn.com
http://www.compareandmerge.com

Alice · Joined: 29 Jan 2015 Posts: 282

An 'Enable' / 'Disable' per 'Pairing' sounds interesting. Maybe a 'checkbox' next to each would be good.

Similar to VV Engine 'Enable/Disable' Profile options ?

Issue has been raised before :

'Execute One Pair in a Multi-Pair Profile'

https://www.tgrmn.com/web/forum/viewtopict4733.htm

TGRMN Software · Site Admin Joined: 10 Jan 2005 Posts: 8769

In the new upcoming ViceVersa PRO 6, there will be the ability to right-click on a single pair and only compare/work with that pair. Cool

_________________
--
TGRMN Software Support
http://www.tgrmn.com
http://www.compareandmerge.com