Author |
Message |
KillingJ Guest
|
Posted: Tue Aug 28, 2018 12:19 pm Post subject: Not detecting changes |
|
|
I have a profile using UNC (\\servername\path\) paths from one server to another server. When I run the profile manually or schedule VVEngine to run every X minutes it pushes the changes over, but if I set it to monitor source and run only when changes are detected - its not detected when changes occur.
It's important to keep these two load balanced servers in sync. Is there a better way to set this up? |
|
Back to top |
|
|
TGRMN Software Site Admin
Joined: 10 Jan 2005 Posts: 8763
|
|
Back to top |
|
|
|
|
You can post new topics in this forum You can reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © phpBB Group
|