command line

[fpefpe]

is there a command line interface like robocopy

[TGRMN Software]

Hello, yes, here is an extract from help file:

Command Line Parameters With or Without a Profile File (.fsf) Specified:
ViceVersa.exe ["profilename.fsf"] [/autocompare] [/hiddenautocompare] [/autoexec] [/dialogautoexec] [/hiddenautoexec] [/wait] [/autoclose] [/console] [/pause:x] [/showtrayicon] [/rescan] [/source:"xxx"] [/target:"xxx"] [/incsub] [/comptype:x] [/ign2secs] [/ign1hour] [/exec:x] [/log:"xxx"] [/emptylog] [/speed:xxx] [/createfolders] [/logonlysumerr]

Command Line Parameters for Automatic Snapshot Creation:
ViceVersa.exe "snapshotname.vsn" /source:"xxx" /createsnapshot [/console] [/pause:x] [/showtrayicon] [/logonlysumerr] [/incsub] [/comptype:x] [/ign2secs] [/ign1hour]
In this configuration the snapshot "snapshotname.vsn" is created with the content of the source.

Command Line Parameters for Automatic Snapshot Comparison:
ViceVersa.exe "snapshotname.vsn" [/source:"xxx"] [/autocompare] [/hiddenautocompare] [/console] [/pause:x] [/showtrayicon] [/logonlysumerr] [/incsub] [/comptype:x] [/ign2secs] [/ign1hour]
In this configuration the snapshot is compared vs the source. If a source is not specified, the snapshot is compared vs the directory where the snapshot is stored.


Command Line Parameters for Automatic License Code Registration:
ViceVersa.exe /writeregkey:"AAAA|BBBB" [/elevated]
These command line options can be used to enter the ViceVersa license code during automatic installations. See more info in table below.

**** For exit codes returned by ViceVersa see Exit Codes ****
_________________
--
TGRMN Software Support
http://www.tgrmn.com
http://www.compareandmerge.com