Author |
Message |
kenshin Guest
|
Posted: Fri May 13, 2016 6:33 am Post subject: Detect changes from source |
|
|
Hi,
VVLaucher has this ability to run a profile as soon as it detects a change from the source. However, I have a large amount of data at the source. When it starts running the profile, it will take a very long time to re-compare the files.
Is there a way to maintain the list of compared files?
Eg: It takes 24 hours to compare 1000000 folders/files. But after finishing the replication, if I were to add 1 more file into the source, will it be able to just detect the 1 change and complete it instantly rather than comparing the source and target folders again.
Regards,
kenshin |
|
Back to top |
|
|
TGRMN Software Site Admin
Joined: 10 Jan 2005 Posts: 8763
|
|
Back to top |
|
|
|
|
You can post new topics in this forum You can reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © phpBB Group
|