Target folder not found

raistlin295 · Joined: 21 May 2014 Posts: 51

I've been using VV and VV engine to do realtime backups for quite some time without any problems.

However, following a recent re-install, I seem to have a problem.

VV works perfectly and finds both source and target folders when run.

One source is on my PC and the other source is a NAS drive. Both Targets are on my NAS.

When using VVE, I get the error as shown in the subject.

I followed the diagnosis provided and used both mapped and UNC descriptors for the folders and it makes no difference. I do not use VV as a service.

Please can anybody point me in the right direction?

Thank you.

TGRMN Software · Site Admin Joined: 10 Jan 2005 Posts: 8763

If you need to login the NAS drive, enter that info in the ViceVersa profile settings -> folders -> network. Then still use the UNC paths. thanks
_________________
--
TGRMN Software Support
http://www.tgrmn.com
http://www.compareandmerge.com

Guest · Posted: Tue Sep 16, 2014 6:05 am Post subject:

Thanks for your reply.

Problem is now solved and was traced to a sharing issue with the NAS.