Err: Subfolder filter "..." does not apply to

[smw]

Update: I suddenly realized that I should not have used the Select Folder browse to select the subfolder, that ends up including the entire path when what is needed is just the portion of the path relative to the source folder. My bad.
----------

I have set up a new profile to mirror contents of a folder to another drive, and excluded one folder in the source. When I run the profile I get the following error (edited): Subfolder filter "D:\Users\...\...\...\subfolder" does not apply to neither source or target folder(s).

Ignoring the double negative for the moment , the folder does exist in the source drive. I used the SubFolder Filters dialog to add the folder in, using the Select Folder button and browsing for it.

I would not be as bothered by the error occuring, if the Mirror job then executed. But it does not. VVPro just stops.

Any suggestions very much appreciated.

[TGRMN Software]

OK, thanks
_________________
--
TGRMN Software Support
http://www.tgrmn.com
http://www.compareandmerge.com