Problem ejecting USB mass storage device

RixNox · Joined: 21 Dec 2013 Posts: 50

Once VVEngine is configured with File Monitoring:
- Monitor Source and Run When File Changes Are Detected
- Monitor Target and Run When File Changes Are Detected
- Monitoring level-> File Level

I cannot eject the target device (USB external disk).
Is there a way to instruct VVEngine to close open handles and unload the drive? Or simply close all open handles?

RixNox · Joined: 21 Dec 2013 Posts: 50

It looks like stopping the profile & disabling it solves the problem. This means you have to remember to enable the profile once done. Maybe you could add an option to automate this, such as stop profile and eject device?

TGRMN Software · Site Admin Joined: 10 Jan 2005 Posts: 8758

Hi, this is due to monitoring the target files (files on the USB drive). Do you need to have that or you could monitor only files on the source.
thanks
_________________
--
TGRMN Software Support
http://www.tgrmn.com
http://www.compareandmerge.com

Guest · Posted: Fri Dec 27, 2013 12:30 pm Post subject:

Ah well, yes it could be possible for to monitor only changes on the Source as the target is for back/sync purposes on the other computer.ù

Would this work with the initial full resync, once the external disk is plugged in?

TGRMN Software · Site Admin Joined: 10 Jan 2005 Posts: 8758

Hi, yes that would work without monitoring target too.
_________________
--
TGRMN Software Support
http://www.tgrmn.com
http://www.compareandmerge.com