Leaving dir attachments as (none)

[jpjordan]

When I run Version 2 against any network attched drive it puts an extra line in the attached drive lists. This primarily shows up in the list to disconnect drives. And it does not go away unless I specifically detach that line. If I have drive Z attached to //4.2.2.2/c$ and I run the program comparing something on drive Z it ends up with Z listed normally, but also lists the following:
(none) //4.2.2.2/c$

If I have the prescript map a drive it attaches and disconnects properly but still leaves the (none) line in the list to disconnect drives.

THIS DID NOT DO THIS ON VERSION 1 and it is happening on several Windows 2000 machines.

Please advise
Paul

[TGRMN Software]

Hello
please try to check which connections you have with the share using the NET USE command.
thanks
_________________
--
TGRMN Software Support
http://www.tgrmn.com
http://www.compareandmerge.com